Here is a DIY DSLR Digital camera Slider I made for below 9 {dollars} with components I picked up from the House Depot. I received the principle thought from Movie Riot’s thought, then tweaked it to wish much less instruments for meeting.
Here is Movie Riot’s Video:
Consider, the footage on the finish IS jumpy. However, it was taken proper after I put the slider collectively and… it is an $8 construct. I might’ve taken it in and warp stabilized the footage, however that basically would not have been an correct illustration of how the slider actually capabilities.
A lot of it’s defined within the video, however this is a components checklist for these of you who’re . The whole lot may be discovered on the House Depot. Offered they nonetheless inventory this stuff if you see this. 🙂
2 pcs – ½ inch conduit. (Minimize to desired size)
4 pcs – ½ inch Electrical Metallic Tube (EMT) Set-Screw Connector. (I discovered 5 pack that was fairly low-cost)
3 pcs – Plastic electrical outlet field. With ½ inch holes.
1 pcs – Electrical outlet field cowl.
About 12 pcs of velcro, reduce ¼ inch broad, ½ inch lengthy.
1 laptop – ¼ inch 20 thread depend screw.
_____________________________________
Gear I exploit for pictures.
https://equipment.com/austinlindsay/gear-for-photography
_________________________________
Gear I exploit for filming.
https://equipment.com/austinlindsay/gear-for-videos
_________________________________
Comply with Me:
Twitter: http://bit.ly/2WNkXiV
Instagram: http://bit.ly/2Im7Wcu
Fb: http://bit.ly/2wZ9Xos
_________________________________
#cameraslider #DIY #howtomake
source